6.
Tack weld the bolt guide block to the lid. Remove the clamp and place the lid on the vault.
Check for interference between the bolt guide block and the front panel. The lid should swing
open and closed without any obstruction. Verify the lock is functioning properly, locking the lid
in place and unlocking to allow it to open.
This is probably the most critical step of the build so
take your time!
Repeat this step if necessary until proper function is achieved.
7.
If you are satisfied with all movement and function of the lid and lock assembly, remove the lock
assembly and weld the bolt guide block into place.
Содержание 100 Series
Страница 4: ...4 Slide the hinge into place in the relief cut underneath the rear panel s top flange as pictured ...
Страница 7: ...9 Weld the front and rear panels on either side of the tab location as shown ...
Страница 13: ...8 Weld the lid corners Grind down the corners to a smooth even radius ...
Страница 16: ...4 Verify proper lid and lock functionality 5 Remove the lock primer and paint it pink and you re all done ...