4.
Insert the lock’s bolt into its slotted arm and through the supplied bolt guide block. Turn the
lock knob to
fully extend the lock arm
(see manufacturer’s instructions for lock operation).
Position the bolt guide block approximately 1/16” away from the slotted arm.
5.
Clamp bolt guide block into place and check the lock function. The lock should open and close
freely without interference with the lid’s front lip or the bolt guide block.
Содержание 100 Series
Страница 4: ...4 Slide the hinge into place in the relief cut underneath the rear panel s top flange as pictured ...
Страница 7: ...9 Weld the front and rear panels on either side of the tab location as shown ...
Страница 13: ...8 Weld the lid corners Grind down the corners to a smooth even radius ...
Страница 16: ...4 Verify proper lid and lock functionality 5 Remove the lock primer and paint it pink and you re all done ...
