Maserati MC20 2022, Руководство пользователя

Страница: 189 / 288

5
185
Starting and Driving
Certain speeds, braking forces and
ambient conditions (e.g. temperature,
humidity and long outdoor stopping
periods) can therefore cause the
brakes to "squeal". This is normal and
will cease after a few brakings.
New Brake Pads and/or Brake
Discs
New brake pads are already “bed in”,
and therefore immediately attain
optimal friction to the brake disc.
During the first period, the braking
system may make a noise, but it will
disappear over time.
Brake Overheating
Driving on mountain roads with steep
slopes or a sports use of the vehicle
could overheat the brake system
components. In these conditions,
parking brake must not be used since
the push of the power actuator might
not be sufficient to ensure vehicle
braking, especially on a slope.
Drive normally without braking to
allow the brakes to cool down a few
minutes before stopping. In this way,
the automatic or manual activation of
the parking brake will ensure vehicle
braking.
Brake overheating could also cause
"squeals" and "vibrations".
Carbon Ceramic (CCB) Brakes
( )
High performance CCB braking system
has been designed to guarantee the
highest possible level of safety when
braking.
When braking the braking system may
make a noise, the intensity of which
depends on the speed, braking force
and environmental conditions (e.g.
temperature, humidity).
The degree of wear and tear of the
various braking system components,
such as brake pads and discs, depends
to a large extent on driving style
and conditions of use and cannot be
expressed in terms of mileage.
CAUTION!
The wear and tear of the braking
system components increases
significantly when the vehicle is used
in heavy duty conditions (if the vehicle
is frequently used on the track or in
heavy traffic).
Use of the Engine
Breaking-In
Today's most modern production
methods are designed to provide
extremely precise construction and
assembly of components. However,
moving parts do undergo a settling
process, basically in the first hours of
vehicle operation.
Do not drive keeping at a constant
high speed rate for a prolonged time.
While cruising, brief full-throttle
acceleration within the limits of
local traffic laws contributes to a
good break-in. Wide-open throttle
acceleration in low gear can be
detrimental and should be avoided.
The engine oil installed in the engine
at the factory is a high-quality energy
conserving type lubricant. Oil changes
should be consistent with anticipated
climate conditions under which
vehicle operations will occur. For the
recommended viscosity and quality
grades, see "Refillings Table" in
section “Maintenance and Care”.
A new engine may consume some
oil during its first few thousand
kilometers of operation. This should
be considered as normal and not
interpreted as an indication of
malfunction.