Marvel MLRI224, Руководство пользователя

Страница: 12 / 43

Water
Supply Line
Clamp and
Screw
Water valve
inlet
Figure 7
Back view of
ice machine
Water line from water
valve to ice-maker
Compression
Water
supply
line
Water supply
service loop
Water valve
inlet
INSTALLING THE WATER SUPPLY
• Do not use any thread sealers on these water
• Reverse osmosis, softened water, and deion-
ized water are not recommended as they will
adversely affect the quality of the ice.
NOTE
!
CAUTION
Water Supply
Observe and follow all local building codes when
installing this appliance.
Use
1
4
" outside diameter copper tubing for your
water supply which is available at any local hard-
ware or plumbing supply store. Bend the
1
4
" copper
tubing to suit your installation being sure not to kink
the tubing. Purchase enough copper tubing length
and coil it behind the unit to form a "service loop"
which will allow the appliance to be pulled out from
the installation for servicing or cleaning. Connect
the copper tubing to the "top side" of a cold water
pipe to prevent the ice-maker from plugging with
sediment.
A shutoff valve is recommended on the water
supply line to ease servicing the appliance. NOTE:
A SELF-PIERCING TYPE VALVE IS NOT REC-
OMMENDED as they are prone to clogging with
sediment which will create pressure drop reducing
the water supply to the unit.
Connect the copper tubing water supply to the
provided. Secure the water supply line to the back
of the cabinet with the screw and clamp provided in
Water pressure must be at a minimum of 20 psi for
proper operation and a maximum of 120 psi.
Make certain all water connections are watertight
after installation. Form the tubing so that it will not
vibrate against the cabinet body or kink when your
appliance is set in position.
12