MARUTI SUZUKI 800, Руководство по обслуживанию

Страница: 386 / 644

FUEL PIPE
REMOVAL
1) Relieve fuel pressure in fuel feed line according to procedure on
p. 6-4.
2) Disconnect negative cable at battery.
3) Disconnect fuel hose from fuel pipe at the front and rear of each
fuel pipe.
4) Remove pipe cover from body.
5) Put clamp position mark on pipes so that clamps can be
installed on original position.
6) Remove pipes with clamp from body.
7) Remove clamp from pipes.
WARNING:
A small amount of fuel may be released after fuel hose is
disconnected. In order to reduce the chance of personal
injury, cover hose and pipe to be disconnected with a
shop cloth. Be sure to put that cloth in an approved con-
tainer when disconnection is completed.
INSTALLATION
1) Install clamps to marked position on pipes referring to the figure
in p.6C-2. If clamp is deformed or its claw is bent or broken, re-
place it with new one.
2) Install pipes with pipe clamp to body.
3) Install pipe cover to body. Be sure to use new nuts.
4) Connect fuel hoses to fuel pipes.
5) With engine “OFF” and ignition switch “ON”, check for fuel
leaks.
FUEL FILLER CAP
Remove cap (1), and check gasket (2) for even filler neck imprint,
and deterioration or any damage. If gasket is in malcondition, re-
place cap.
NOTE:
If cap requires replacement, only a cap with the same features
should be used. Failure to use correct cap can result in critical
malfunction of system.
6C-4 ENGINE FUEL