1
UNPACKING
Each Martin Audio MA Series amplifier is built to the highest standard and
thoroughly inspected before it leaves the factory. After unpacking the unit,
examine it carefully for any signs of transit damage and inform your dealer
if such damage is found. It is suggested that you retain the original
packaging so that the unit can be repackaged at a future date if necessary.
Please note that Martin Audio and its distributors cannot accept
responsibility for damage to any returned product through the use of
non-approved packaging.
2
WARNINGS
•
Do not use this amplifier if the mains cable is damaged.
• Always operate the amplifier with the chassis ground wire connected
to the electrical safety earth.
• Do not parallel or series connect an amplifier output with any other
amplifier output. Do not connect the amplifier output to any other
voltage source, such as battery, mains source or power supply,
regardless of whether the amplifier is turned on or off.
• Do not run the output of any amplifier back into another channel's input.
• Do not block the air intake or exhaust ports.
•
Do not operate the amplifier near any source of heat.
•
Do not spill water or other liquids into or on the unit.
Do not operate the amplifier if liquid ingress is suspected.
• Do not remove top or bottom covers. Removal of the covers will
expose hazardous lethal voltages and may void warranty.
There are no user serviceable parts inside the amplifier.
Refer servicing to qualified personnel only.
• Keep this manual for future reference.
Martin Audio – MA1.3 Power Amplifier
E
NGLISH
2
This equipment conforms to the requirements of the
EMC Directive 89/336/EEC, amended by 92/31/EEC
and 93/68/EEC and the requirements of the Low
Voltage Directive 73/23/EEC, amended by 93/68/EEC.
Standards Applied
EMC
Emission
EN55103-1:1996
Immunity
EN55103-2:1996
Electrical Safety
EN60065:1993
CONTENTS
<
>
GUIDES
