Marshall Electronics VS-570-HDSDI, Руководство пользователя

Страница: 14 / 54

VS-570-HDSDI User Manual
2.0 Megapixel Speed Dome Manual
14/54
Camera Installation using Brackets
Installation using a Ceiling Mount Bracket (not supplied)
①
Remove the ceiling tile from the ceiling and cut a
hole whose diameter is 30~40mm on the ceiling tile
to pass the wire(s) and cable(s) through to the
upside of the ceiling. Then prepare the ceiling
mount bracket. Pull the wire(s) for the system
as below.
(Anchor Bolt 3/8"
×
70)
②
Hook up the “Drop Prevention Spring” on main body
to prevent the camera from unexpected drops. Pull
the wire(s) and cable(s) for the system as shown below.
③
Align the index marks and assemble the main
body to the mounting adaptor and turn it. Attach
the main body to the camera mounting adaptor
with the included screws. (Torx screw M4X18).
Please make certain the screws are securely
or
tightened to maintain a waterproof seal.
④
Screw the dome cover to the main body and
remove the protection vinyl from the dome cover.
Notice

Before starting the installation, make sure that the Camera ID and Protocol are set up properly.

To adjust the installation height from the mounting surface, pipes and couplers may be needed
between the surface mount part of the ceiling mount bracket and the camera mount part of the ceiling
mount bracket. Please note that these are not supplied by the manufacturer.