MARS COMMERCE SOLO-NX, Инструкция по эксплуатации

Страница: 28 / 35

SOLO-NX
INSTALLATION MANUAL
Page 28
10.14 RECEIVE CREDIT PARS PARAMETERS (PCREF)
By sending this command to SOLO-NX you receive SMS message with all currently programmed
credit parse parameters (CREF, CVODA…):
;PCREF;
10.15 RECEIVE ALL CLIP PARAMETERS (PCLP)
By sending this command to SOLO-NX you receive SMS message with all currently programmed
CLIP functionality related parameters (CLPEN, CLPOU, CLPI, CLPx):
;PCLP;
NOTE
User can use ;PCLP=x,y; to limit the number of CLIP numbers to be printed.
x = start number
y = end number
Example
;PCLP=1,30; Prints first 30 CLIP numbers
10.16 RECEIVE INTERCOM BUTTON 1 PARAMATERS (PDEA)
By sending this command to SOLO-NX you receive SMS message with all currently programmed
button 1 group parameters (ATN1, ATN2, ATN3, ATN4, ATN5, RTNA, SDNA, SDDA, TZSA,
TZEA):
;PDEA;
10.17 RECEIVE INTERCOM BUTTON 2 PARAMATERS (PDEB)
By sending this command to SOLO-NX you receive SMS message with all currently programmed
button 2 group parameters (BTN1, BTN2, BTN3, BTN4, BTN5, RTNB, SDNB, SDDB, TZSB,
TZEB):
;PDEB;
10.1 RECEIVE INTERCOM BUTTON 3 PARAMATERS (PDEC)
By sending this command to SOLO-NX you receive SMS message with all currently programmed
button 1 group parameters (CTN1, CTN2, CTN3, CTN4, CTN5, RTNC, SDNC, SDDC, TZSC,
TZEC):
;PDEC;
10.2 RECEIVE INTERCOM BUTTON 4 PARAMATERS (PDED)
By sending this command to SOLO-NX you receive SMS message with all currently programmed
button 2 group parameters (DTN1, DTN2, DTN3, DTN4, DTN5, RTND, SDND, SDDD, TZSD,
TZED):
;PDED;