SOLO-NX
INSTALLATION MANUAL
Page 12
9.2
OUTPUT MANAGEMENT
SOLO-NX supports the possibility to report alarms from inputs and any other events locally via 2
outputs. The behavior is defined using next parameters
9.2.1
OS parameter
SOLO-NX device has 2 dedicated relay supported outputs. Outputs can be configured to different
behavior:
OS = 0
– Disabled
OS = 1
– Bi-stable toggle mode
OS = xxx
– Mono-stable pulse mode (duration in seconds)
Typical connection for the output:
R=1k
Ω
LED
Output 1-2
+12V DC
RELAY
12VDC
Output 1-2
+12V DC
Figure 3:
Output Connection diagram
9.2.2
OD parameter
OD parameter is used to link the alarm event directly to output.
9.2.3
OP1, OP2 parameters
Parameters are used to invert the polarity of the outputs.
0 – normal
1 – inverted
