SOLO-NX
INSTALLATION MANUAL
Page 10
9.1.2.1
TN parameter
Telephone numbers for remote alarm reporting are listed as TN parameters. Remote alarm reporting
on SOLO-NX is done via SMS messages.
9.1.2.2
LN parameter
This parameter is used to link alarm event from inputs or any other source to the telephone numbers
from TN list.
9.1.2.3
LOT parameter
LOT parameter is used to define the time control for voice calls. The start of voice connection starts
the LOT timer. If the voice connection is still ON when the LOT timer expires SOLO-NX
disconnects voice connection.
9.1.2.4
Table of parameters
Name
Comment
TN1
1
st
telephone number
TN2
2
nd
telephone number
TN3
3
rd
telephone number
TN4
4
th
telephone number
TN5
5
th
telephone number
LN1
Input & telephone No. linking for 1
st
alarm input (TN1 – TN5)
LN2
Input & telephone No. linking for 2
nd
alarm input (TN1 – TN5)
LN3
Input & telephone No. linking for 3
nd
alarm input (TN1 – TN5)
LN4
Input & telephone No. linking for 3
nd
alarm input (TN1 – TN5)
LN5
Periodic test SMS. No. linking (TN1 – TN5)
LN6
SIM card refill. No. linking (TN1 – TN5)
LN7
NAC list. No. linking (TN1 – TN5) (see note)
LN8
Log status. No. linking (TN1 – TN5)
LOT
Time out for GSM connection.
Table 3: Remote alarm reporting parameters
NOTE
When telephone number (calling or messaging SOLO-NX) is not on the CLIP list, not
acknowledge event occurs (NAC). The telephone number responsible for this event
can be send to TN user for notification.
