Gas Conversion for Top Convertible Pilot (Series 019065X)
1. Shut off the gas supply to the appliance.
2. Allow the pilot burner to cool to room temperature.
WARNING: Touching a hot pilot burner can result in
injury.
3. The pilot hood is held in place by spring pressure.
Remove the hood by pulling it directly up from the pilot
bracket (Figure 20a).
4. Insert a 5/32” or 4mm Allen wrench into the hexagonal
key-way of the injector (Figure 20b), and rotate it
counter-clockwise until it is free of the injector journal
(Figure 20c).
5. Verify that the new injector is proper for the application.
The injector size is stamped on the side of the injector
near the top. LPG injectors have a groove machined
around their circumference near the top, while NG
injectors do not have a groove (Figure 20e). Refer to the
Appliance Manufacturers instruction sheet for the proper
injector size.
6. Insert the Allen wrench into the end of the injector. Then,
insert into injector journal, and rotate the injector
clockwise until a torque of 9 in-lbs is achieved.
7. Replace the pilot hood by aligning the tab on the base of
the hood with the slot in the side of the pilot journal, and
push the hood down, directly onto the pilot bracket
(Figure 20d). The hood must sit squarely on the bracket
for proper operation. Check to insure that the hood is
properly seated onto the pilot bracket.
(a)
(b)
(c)
(d)
(e)
Figure 20 - Pilot conversion process illustration.
Instructions for converting SIT 190 series pilot burner injection from NG to LPG and from NG to LPG only. This
information should be considered as supplemental to the Appliance Manufacturer’s Instructions.
WARNING
The installation of this conversion kit must only be undertaken by a qualified and certified gas appliance
installer.
WARNING
This conversion kit must only be applied as part of a conversion kit supplied by the appliance Manufacturer for the
specific appliance, and type of gas being converted. INSTALLER NOTICE: These instructions must be left with
appliance.
36
