Maretron DSM410, Руководство пользователя

Страница: 18 / 289

DSM410
User’s Manual
Page 2 Revision 1.7.2
2 Installation
2.1 Unpacking the Box
When unpacking the box containing the Maretron DSM410, you should find the following items:

1
– DSM410 NMEA 2000
®
Multi-function Graphic Display

1
– DSM410 Bezel

4
– Mounting Screws

1
– DSM410 User’s Manual USB Flash Drive

1
– Warranty Registration Card
If any of these items are missing or damaged, please contact Maretron.
2.2 Choosing a Mounting Location
The DSM410 is housed in a waterproof enclosure (IEC IP67 rating
– protected against the effects of
temporary immersion in water) and can be mounted in either an outdoor location or an indoor
location.
2.3 Mounting the DSM410
The DSM410 can be flush mounted. Maretron suggests a location at which the display can be viewed
from a relatively straight angle, and at which the keys are easily touched.
2.3.1 Flush Mounting the DSM410
The DSM410 can be directly mounted to any suitable surface. You may choose to secure the
DSM410 to the mounting surface with the included wood screws or machine screws, or you may use
silicone or a similar adhesive if you do not have easy access to the rear side of the mounting surface.
The steps for this type of mounting are as follows:
1. Attach the Mounting Template (see Section 13) to the surface where the DSM410 is to be
located.
a. Make sure the template is level by using one of the horizontal lines as a guide.
b. Scotch tape works well for securing the template.
2. If securing with machine screws, drill the four mounting holes all the way through the mounting
surface at the locations indicated on the Mounting Template .
a. Use a 4.3mm or
0.17” drill bit.
3. Cut a hole for the body of the display.
4. Remove the template from the mounting surface.
5. Place the DSM410 on the mounting surface, with the body of the DSM410 inserted into the
large hole. If mounting with silicone adhesive, apply the adhesive to the portion of the DSM410
that will come into contact with the mounting surface once installed.
6. If mounting with machine screws, insert the screws into the front of the DSM410 and tighten to
nuts on the back side of the mounting surface.
a. Use M3 machine screws.
b. D
on’t over tighten the screws.
7. Snap the bezel over the DSM410. Please pay attention to the orientation of the bezel. The top
and bottom edges of the bezel and the DSM410 have one snap fitting, while the left and right
edges have two snap fittings.