10 - Installation manual - Eletta
®
3.2.3 Installation of the lateral driving units - electric version
The first elements (1 per side) to be installed on the front cab guard are the side transmission groups right and left, to be
placed on the front of the tipper.
Side transmission group - right
Side transmission group - left
•
Position the unit as in figure, by joining the support plate to the side of the cab guard of the vehicle and adjacent to the
front part.
•
The unit is fastened laterally with 2 countersunk screws (
A
) and nuts. However, if there are impediments on the side to
the correct fastening, it can be made also with the seats positioned on the upper rear part (holes for hexagonal-head
screws
B
) or upper front (hole
C
).
•
Proceed fastening the element to the cab guard using the screws, washers and self-locking nuts supplied, or
alternatively (if the thickness allows it) threaded M8 and tighten the screws, making sure to insert suitable thread locker
Note:
In this case we recommend to use oil tolerant Loctite 243 medium strength, or alternatively Loctite 262 medium
strength.
At this point the first lateral transmission assembly is fastened and it is possible to proceed with the fastening of the
second.
•
Proceed fastening in the same way as the previous group, paying attention to the alignment of the two groups.
