8716P Hybrid NVR Installation Guide
30
Unit Setup
5
Mark the locations of the two left mounting holes.
6
Remove the recorder from the mounting screws and put it aside.
7
Install the left mounting screws at the marked locations.
•
If the left mounting location is in a wall stud, thread the screw directly into the wall stud.
•
If the left mounting location is in drywall, first install a drywall anchor, and then thread the
screw into the drywall anchor.
Do not thread the mounting screws all the way in. The screw heads should protrude
approximately 0.25 inches (0.64 centimeters) from the mounting surface so that you can
hang the recorder on them.
8
Hang the recorder on the mounting screws. You can mount the recorder with the faceplate up
or down, but the underside of the recorder (with the feet) must always face the wall.
The recorder drops approximately 0.5 inches (1.27 centimeters) when hung on the mounting
screws. The screws lock into the mounting hole keyways, providing a positive locking
mechanism.
9
Tighten the mounting screws.
Desk-Mounting the Recorder
The unit is shipped with rubber feet attached to the bottom of the unit, so that you can safely
mount it on a desk.
WARNING:
To ensure the unit meets the recommended operating temperature, the unit must be desk-
mounted in a location that ensures that it is unobstructed on all sides.
ATTENTION :
Pour garantir que l'unité respecte la température de fonctionnement recommandée, l'unité
doit être montée sur un bureau dans un endroit qui garantit qu'elle est dégagée de tous les côtés.
Mounting Screw
Recorder
