2-3
How to remove the loading motor (See Fig. 2-1.)
1. Remove the lift lever.
2. Remove the screws (A1) x 4 pcs., to remove the gear cover.
3. Remove the screws (A2) x 2 pcs., to remove the loading mo-
tor.
(Adjusting the SACD mechanism completed products)
It is necessary to position the spindle motor, the sub-shaft
(mechanism), and the pickup to play a nonstandardized SACD
disc. If the pickup or motor is replaced at the service division,
these adjustments cannot be performed because of the facility
and measuring equipment matters.
The SACD mechanism completed products are adjusted for
the above reasons.
After installing:
After installing the SACD mechanism completed product,
remove the two solders shown below.(See Fig. 2-2.)
[REMARK]
• The two solders are used to eliminate static electricity before
installing the SACD mechanism completed product.
(A2) x2
ø1.7x2mm
(A1) x4
ø2x5mm
Gear Cover
Loading
Motor
Lift Cover
Remove these two solders after installing
the SACD mechanism completed product.
Figure 2-2
Figure 2-1
Содержание F1N
Страница 26: ......