5. Normal Firmware Update Method from USB Flash Drive
5.1. File structure on USB flash drive
Copy the normal update files onto the USB flash drive in the following structure.
After unzipping the HW component USB update files for the target model and LEGO USB update files,
store them in the root of the same USB flash drive.
Model Area
Download from SDI
For HW component
For LEGO component
North America (U)
DPMS_AV7703U_LEGO_PopupNone_xxxx.zip
Product ID : 100100520100
heos_40.prod_x.xxx.xx.zip
Europe (N)
DPMS_AV7703N_LEGO_PopupNone_xxxx.zip
Product ID : 100100520200
USB flash drive root
+ AV7703x_xxxx.update.auto
+ heos_40.prod.update.x-xxx-xx
5.2. Start normal update
NOTE :
• Remove the LAN cable from this unit when updating.
(Do not connect to a wired or wireless network.)
(1) Press the power button to turn on the power.
(2) Wait for this unit to start up.
(3) Set the input source to Online Music.
Sub Display
L1
–TuneIn Internet Radio
or
No Network Connection
L2
HEOS Favorites
L1 : Content of the display is scrolled.
(4) Insert the USB flash drive into the USB port.
Download firmware
in USB flash drive.
(5) USB Update starts automatically.
The Standby LED lights red.
Display during USB update (Main Display)
L1
Wait
L2
–––––
↓
L1
Updating
L2
––– xx%
L3
xxmin
↓
L1
Update
L2
Completed
It takes a maximum of approximately 25 minutes for update to complete.
(6) The unit restarts when update is complete.
(7) After updating the firmware, check the version.
"
• If it takes more than 90 seconds to display the HEOS Version, perform "
Firmware Factory Restore
"
and then perform "
5.2. Start normal update
" again.
(7) Execute Firmware Factory Restore.
---Cautions on Firmware Update---
• Do not remove the USB flash drive until updating is completed.
• Do not turn off the power until updating is completed.
• It takes a maximum of approximately 25 minutes for update to complete.
Once an update is started, normal operations cannot be performed until it is completed.
The GUI menu settings and image adjustment settings of this unit may be initialized.
Note down the settings before updating, and set them again after updating.
186
Caution in
servicing
Electrical
Mechanical
Repair Information
Updating