INSTALLATION
1 )Use a
driver Insert into the hole located on the bottom
of the unit, and depress to unlock the battery cover and
slide
it to remove.(fig. l)
2) Insen 3 •AA" batteries (not included), two beeps will sound.
Refit the battery cover
3) Press any key and you will hear the key tone. If this sound is
not hard or is dull
slurry, replace the battaies.
4) For best perf01TN.oce
Alkaline b&taies ge
Number)
(fig. 1)
the battaie are
the pre-set code is 333.
TO SET YOUR OWN PERSONAL CODE: (You have to enter the new code within IS seconds.)
1) Press the
•r fi•nction key, that
333.
red r FD wül illuninate.
2) Enta your own pawnal 3 diöt code. The red LED *111
go out, and one long beep 49111
sound to confim your
new code
3) To change your
code, follow
above procedure.
ADWSTNG THE Tru DELAY
I ) To change the pre-se 3 econd attry dday, pres
åmction k" thal the•@• time k%'. Select ymar &ice
your
of 3, 15, or 30 seconds entry dday by preing then*
l, 2 or 3 respectively. One bep wül
to
setting.
2) To c.intze tbe pre-sa 10
ecit delay, press
ffnction kø
choice of I O, 20, or 30 seconds ecit delay by preütg the number 4. 5 or 6 k"
to confirm your setting.
3) To change the pre-set 30
alarm duration,
the "F' ftanction key then
ot300r-60seéondsalum duntion
Of-bk
confirm your sating
R€STALLATION
select your
One bep will
tinrk%'-
l) Select the entrance to be protected, but avoid direct aanliøtt or rain
to the unit.
2) The unit is desk and wall mountable. However, for the best deection coverage, the urüt åould be placed or
mounted 3 to 7 feet above the floor. The av«age deection coverage provided by the alarm unit is 20 feet in a 89
degree arc.
3) To mount on the wall- Use the supplied screws or the double sided adheive pads to mount the battery cover on
the location you have sele<ed. Place the unit over the bütay cover and slide the unit omo the battery cover.
NOTE: Whenever you want to remove the battery cover, be
to unlock the battery
as described in
"battery installation"
The visitor chime ffnction will only work in the DISARM mode.
I ) Press the "F" fianction k". then the " Q " bell key, the Ding-Dong chime will play twice to confirm the unit is in
visitor chime mode.
2) Wait for 15 seconds for unit warm up. Once activated, the unit will sound Ding-Dong twice each time ,it senses
any movement.
3) Place/mount the unit nar the entrance to detect a visitor's entry or exit.
TO DEACTIVATE THE VISITOR CHmE FVNCTION
Press the "F" mnction key, then the " O " bell key .You will hear two beeps to confim the visitor chime
is
off.
PANIC ALARM
In the event of
emergetcy, an immediate alarm can be triggered by simultaneously pressing the •F' Ranction key
and tlE
lock key. The alarm will sound for 30 seconds.