Maple Systems Silver HMI504T, Инструкция по установке и эксплуатации

Страница: 93 / 272

However, if Popup Window #12 had the coherence feature enabled, a different picture would have occurred.
Although Popup Window #12 was displayed after Popup Window#13, it appears behind it. Even if the OIT
operator ‘activates’ Window #12 by touching some object on that window, it will remain behind all other popup
windows displayed.
š
If two popup windows are displayed with the coherence feature enabled on both, then
the popup window that is displayed first will be the dominant window.
Coherence is most often used on popup windows that take a large area of the OIT display. When they are displayed,
they often completely cover smaller popup windows that are already on display, making it difficult to access the
covered popup windows.
Set ting the Win dow Se cu rity Level
EasyBuilder provides the ability to restrict access to window screens so that only authorized personnel can view
them. Three security levels are available: Level 0 (Lowest), Level 1 (Middle), and Level 2 (Highest).
You must perform the following three steps to use the Window Security Level feature:
1. Assign passwords to the three levels of security access.
2. Assign a security level to each of the window screens.
3. Create a Numeric Input Object that allows you to change the current access level.
4
To assign Window Security Level passwords
1. From the Edit menu, select System Parameters . The Set System Parameters dialog box
appears.
2. Click the Security tab to display the Security form.
3. To enable the Window Security Level feature, check the Security Control box.
4. The Password frame box appears showing the current passwords for the three security levels.
5. Each password can have a value of 0 (indicating no password is assigned to that level) or 1 to
4,294,967,295. After entering a password for each level, click
OK
to go back to the main
screen of EasyBuilder.
These passwords must be entered by the OIT operator to gain access to any window screens that are assigned a
security level.
4
To assign a security level to window screens
1. All window screens are initially configured with the lowest level security access allowing
total accessibility. To change the level of access, you must change the window screen’s
security level in the window settings dialog box.
2. From the Window menu, select Open Window . The Open Window dialog box appears.
3. Click on the window you wish to modify, and then click the
Setting
command button. The
Window Setting dialog box appears.
1010-1001a, Rev 02
Cre ating Win dows 89