Mapal WTE HPH, Инструкция по установке и эксплуатации

Страница: 37 / 64

36
Montage- und Betriebsanleitung
Installation and Operating Instructions
EN
33 SSaaffeettyy
33..11 TTaarrggeett ggrroouupp
The HPH clamping chuck may only be used by trained, authorised and dependable specialist personnel. The specialist per-
sonnel must be able to recognise and avoid hazards and for this purpose must have read this document before using the
HPH clamping chuck.
The specialist personnel is familiar with the health and safety regulations, safety stipulations and instructions from the ma-
chine manufacturer, which must be followed and observed during operation of the HPH clamping chuck.
33..22 CCoorrrreecctt uussee
•
The HPH clamping chuck is intended exclusively for holding and clamping tools on cutting machines in industrial appli-
cations.
•
The HPH clamping chuck has been specially designed for hydraulic clamping of rotating tools on machine tools for man-
ual and automatic tool changing.
•
The HPH clamping chuck may only be used when observance of all the instructions given in this manual is assured.
•
Should a maximum operating speed exist for the tool, it is not to be exceeded.
•
When the tool is used in combination with a clamping chuck, the lowest operating speed from the individual compo-
nents is to be used.
•
By long, protruding and heavy tools or when an extension is used the max. operating speed is to be reduced in accord-
ance with the individual factures.
•
Failure to observe these instruction can result in injuries or damage to machines and accessories for which WTE assumes
no liability.
Montage- und Betriebsanleitung
Installation and Operating Instructions
37
EN
33..33 IInnccoorrrreecctt uussee
•
The HPH clamping chuck, the tool or the tool assembly and further components can only be used in compliance with the
relevant technical data (see
section 4.4) and the max. operating speed is not to be exceeded.
•
The HPH clamping chuck must not be heated on a shrink unit. It is not designed for the shrinking process and the asso-
ciated temperatures.
•
The HPH clamping chuck must not be used for workpiece clamping.
•
The HPH clamping chuck must not be modified and used for other applications.
•
Additional bores, threads and attachment parts may only be attached with the written approval of WTE.
• Unauthorised modifications to the HPH clamping chuck or incorrect use of the HPH clamping chuck will void all and any
warranty claims against WTE.
• The manufacturer assumes no liability for accidents or damage resulting from use for other than the correct use.
33..44 W Waarrrraannttyy
The warranty period is 2244 m
moonntthhss from the date of delivery ex works on condition of use for the correct use and observance
of the contents of the installation and operating instructions.
The HPH clamping chuck including all its components and accessories must not be modified or used for non-authorised ap-
plications. Any modification to the HPH clamping chuck or any unauthorised use will void all and any warranty claims
against WTE.
WTE expressly declines any liability for accidents or damage resulting from the use of damaged tools or damaged machine
parts. Wear parts are not covered by the warranty.
Montage- und Betriebsanleitung
Installation and Operating Instructions
37
EN