1
Page
1
of
3
MAN-MD-H-0226-01
MANTECH AutoMax 197 Autosampler Setup Instructions
1.
Remove the two screws holding the arm lock in place and remove the arm lock. Put it and the two
screws into the accessory bag.
2.
Slide the Z arm mount forward on the Y arm to allow you to access the screw at the back of the Z
arm clamp.
3.
Loosen the screw holding the Z arm clamp and install the Z arm.
4.
Tighten the screw holding the clamp so that the clamp is against the top of the end plate for the
arm.
