Manitowoc Grove GMK 4100L-1, Руководство по обслуживанию

Страница: 303 / 356

Maintenance work on the superstructure
8.9 Cable drums and slewing angle sensor
2
5
.1
1.
201
6
Maintenance manual 3 302 364 en 8 - 67
GMK 4100L-1
8.9.2
Lubricating the slewing angle sensor
Grease, spare
parts, tools
– Grease gun from the tool set.
– Sealing agent (e.g. Hylomar).
– Torque wrench for 25 Nm (18.5 lbf ft).
Prerequisites – The engine must be switched off and secured against unauthorised use;
à
p. 2 - 3.
Lubricating
•
Remove the drain plug ( 1 ).
•
Clean the grease nipple ( 2 ) and inject about
5 cm³ (0.3 in³) of grease.
•
Remove any excess grease, and close the
grease nipple.
•
Tighten the bolt with a new gasket and
sealing agent – torque 25 Nm (18.5 lbf ft).
Y 5
Lubricating
grease
Designation
to DIN 51502
Specification
classification
GROVE part no.
Grease KP - 1K - 50 DIN 51825 03233369
Designation Quantity GROVE part no.
Gasket 16 x 20 Cu DIN 7603 1 00117134
S
Risk of damage to the slewing angle sensor.
Before lubricating, always remove the screw from the slewing angle
sensor.
This prevents the slewing angle sensor from damage.