Manitowoc convotherm 4, Руководство пользователя

Страница: 95 / 140

5.2 Operating principles and instructions for cleaning
5.2.1 Safe working when cleaning
Your safety and the safety of your staff
Before your personnel start working with the combi steamer for the first time, familiarize yourself with
the information contained in the chapter 'For your safety' on page 21 and make relevant safety ar‐
rangements.
Instruct your personnel to learn the safe-working rules given in this section before starting work, and to
follow them strictly.
Instruct your personnel to familiarize themselves with the hazard warnings listed in this section and in
further instructions below, and instil in them the importance of taking the specified precautions.
Personal protective equipment for your personnel
Instruct your personnel to wear the correct personal protective equipment specified in the section 'Per‐
sonal protective equipment' on page 41 of the 'For your safety' chapter for the relevant tasks.
Basic rules for safe operation
If it is known or evident that the combi steamer has been moved after installation without authorization
(whether intentionally or unintentionally), the appliance must not be put back into service until all the
following requirements have been met:
■
The appliance and fittings or accessories being used show no signs of damage.
■
The installed electrical power cables, water supply pipes and pipes for wastewater and cleaning
products show no signs of damage, are fixed securely, are not leaking from any point and appear
safe and in working order on visual inspection.
■
The 'Requirements relating to the operating condition of the combi steamer' on page 22 are met.
■
The 'Requirements relating to the operating environment of the combi steamer' on page 22 are
met.
■
All warning signs are in their designated position.
On gas appliances only:
■
A gas service engineer has leak-tested all the gas components in the combi steamer and con‐
firmed that all connection and supply points for these gas components, inside and outside the ap‐
pliance, are gastight.
Rules for moving and setting up the wheeled base safely
To avoid hazards, the following rules must be observed when moving the wheeled base that carries
the appliances:
■
Before moving, the drain pipe must be disconnected if a fixed wastewater connection is used.
■
Watch out for all connecting cables and pipes when moving appliances. Never wheel over the con‐
necting cables or pipes. Never stretch let alone pull off the connecting cables or pipes. The lengths
of the electrical supply cables and gas and water pipes are chosen to accommodate the range of
movement of the retaining device. Even so, it is essential to watch out for the position and run of all
connecting cables and pipes when moving appliances.
■
The appliances must be disconnected from the electrical supply before moving the stacking kit.
■
The appliances must be left to cool down on the base before being moved.
■
There must not be any food left in the appliances.
■
The appliance doors must be closed.
■
Protective clothing must be worn when moving the base that carries the appliances.
■
At least two people must be used to move the base that carries the appliances.
■
It is important to ensure that the appliance is level once is back in place.
■
Once the unit is back in place, the parking brakes must be engaged again.
■
Whatever the position, care must be taken to ensure that the base carrying the appliance does not
tip over.
5 Cleaning procedures
User manual 95