Manitowoc 16000WA, Руководство оператора

Страница: 63 / 110

Reference
Only
Manitowoc
Published 03-18-13, Control # 116-09
4-33
16000 WIND ATTACHMENT OPERATOR’S MANUAL SET-UP AND INSTALLATION
4
Remove Assembly Block
See Figure 4-20 for following procedure.
1. Position trailer (1, View B) or other means of transport in
front of boom butt (2) as shown. Or, lower the assembly
block onto the ground and remove it with an assist
crane.
2. BOOM DOWN to lower mast (3) to approximately 150°.
3. Guide slings (4) and assembly block (5) around the end
of the boom butt as the mast is lowered.
4. Unpin handling pendants (6, View A) from the mast and
attach the pendants to assist crane block (7) with nylon
lifting slings (8).
5. Support the mast with the assist crane.
6. Lower the mast to the desired position with the assist
crane.
Do not side load mast.
Use the limit bypass switch to bypass the mast limit and
pay out boom hoist wire rope as the mast is lowered with
the assist crane.
7. Lower assembly block (5, View B) onto the trailer or the
ground. Guide the mast straps clear of the trailer, as
required.
8. Remove the wire rope from the assembly block and the
mast and store the wire rope on the whip drum.
9. Raise the mast to at least 150° with the assist crane. As
the mast is raised haul in wire rope on the boom hoist.
10. Once the mast is at or above 150°, support the mast with
the boom hoist wire rope and disconnect handling
pendants (6) from the assist crane block.
11. Position the mast at approximately 140° (View C).
Connect Boom Butt to Boom
See Figure 4-20 for following procedure.
1. Pin handling pendants (6, View D) to lugs (2) on the
boom butt.
2. Boom up to lift the boom butt just clear of the ground.
3. Position the 16000 so the boom butt is in line with the
end of boom (View C).
4. Travel forward and boom down to align hooked
connectors (10, View E) on the boom butt with fixed pins
(11) on the adjacent insert.
5. See Capacity Chart to determine if crawlers must be
blocked to raise assembled length of boom.
If blocking
is required :
a. Mark the ground at front end of the crawler — center
of tumbler on one crawler and center of front roller
on other crawler.
b. Disengage the boom butt from the insert and travel
backwards approximately 4 ft (1,2 m).
c. Install the required blocking at the points marked in
step 5a.
d. Repeat step 4.
6. Boom up slowly (View F) until the bottom connectors are
aligned between the boom butt and the insert.
7. Install pins (12, View G).
8. Unpin handling pendants (6, View D) from the boom butt
and pin them to the mast (View A) for storage.
WARNING
Falling Mast Hazard!
Prevent mast from falling:
• Do not use limit bypass to lower mast below 156° until
mast is supported with slings from assist crane.
• Assist crane must lift 14,000 lb (6 350 kg).
WARNING
Crush Hazard!
Do not stand or work under mast unless it is supported by
assist crane.
CAUTION
Lacing Damage!
Take necessary precaution while storing wire rope on
drum so boom button end of rope does not fall and
damage lacings in boom butt.
WARNING
Falling Boom Hazard
Do not attempt to lift assembled boom with handling
pendants. Handling pendants could break allowing boom
to fall.