Manitou MT 625 H 75K COMFORT ST5 S1, Руководство оператора

Страница: 105 / 136

3 - 19
1
5
6
3
4
2
REPLACE Engine oil *
REPLACE Engine oil filter *
Place the lift truck on level ground, let the engine run at idling speed for a few minutes,
then stop the engine.
t
IMPORTANT
t
Dispose of the drain oil in an ecological manner.
Tighten the oil filter by hand pressure only and lock the filter in place by a quarter turn.
DRAINING THE OIL
-Open the engine cover.
-Remove access panel 1.
NOTE: When removing cover plates and hatches, clean the surrounding area and
remove any accumulations of flammable materials.
-Place a container under the drain hole and unscrew the drain plug 2.
-Remove the filler plug 3 to ensure correct drainage.
REPLACEMENT OF THE FILTER
-Unscrew and discard the engine oil filter 4, together with its seal.
-Clean the filter bracket with a clean, lint-free cloth.
-Lightly oil the seal before refitting the new oil filter (
e
FILTER ELEMENTS AND
BELTS) on its bracket (tightening torque 11 - 12,5 ft-lbs 15 - 17 N.m).
FILLING WITH OIL
-Refit and tighten the drain plug 1.
-Fill up with oil (
e
LUBRICANTS AND FUEL) through filler hole 5.
-Wait a few minutes to allow the oil to flow into the sump.
-Start the engine and let it run for a few minutes.
-Check for possible leaks from the drain plug and the oil filter.
-Stop the engine, wait a few minutes and check the correct level between the two
marks on the dipstick 6.
-Top up the level if necessary.
-Refit the access cover 1.
* Only for the first 50 hours of service and then every 500 hours of service or 1 year.
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1