Manitou MH20-4 T BUGGIE 4ST3B, Руководство оператора, Страница: 87 / 114

3-23
CLEANING THE STRAINER
- Disconnect the clogging indicator 3 (fig. E3/3).
- Disconnect the hoses 4 (fig. E3/3) at the level of the hydraulic return oil filter 5 (fig. E3/3).
- Unscrew the four screws 6 (fig. E3/3) and remove the complete filter 5 (fig. E3/3).
- Unscrew the suction strainer at the bottom of the tank, clean it with the help of a compressed
air jet, check its condition and change it, if necessary (see : 3 - MAINTENANCE : FILTERS
CARTRIDGES AND BELTS).
- Reassemble the strainer, the filter and re-connect the hoses and the clogging indicator.
FILLING UP THE OIL
- Clean and refit drain plug 1 (fig. E4/1) (tightening torque 29 to 39 N.m).
- Fill up with oil (see : 3 - MAINTENANCE : LUBRICANTS AND FUEL) by filler port 7 (fig. E3/2).
Use a clean container and funnel and clean the underside of the oil drum before filling.
- Observe the oil level on dipstick 8 (fig. E3/4) ; the oil level should be at the level of the red point.
- Check for any possible leaks at the drain plug.
- Replace filler plug 2 (fig. E3/2) with a new filler plug (see : 3 - MAINTENANCE : FILTERS
CARTRIDGES AND BELTS).
POLLUTION ABATEMENT OF THE HYDRAULIC CIRCUIT
- Let the I.C. engine run (accelerator pedal at halfway travel) for 5 minutes without using anything
on the lift truck, then for 5 more minutes while using completely the hydraulic movements
(except the steering system).
- Accelerate the engine at full speed for 1 minute, then activate the steering system.
- This operation makes a pollution abatement of the circuit possible through the hydraulic
return oil filter.
E6 - SEAT BELT
CHECK
SEAT BELT WITH TWO ANCHORING POINTS
- Check the following points :
t'JYJOHPGUIFBODIPSJOHQPJOUTPOUIFTFBU
t$MFBOOFTTPGUIFTUSBQBOEUIFMPDLJOHNFDIBOJTN
t5SJHHFSJOHPGUIFMPDLJOHNFDIBOJTN
t$POEJUJPOPGUIFTUSBQ DVUTDVSMFEFEHFT
REELED SEAT BELT WITH TWO ANCHORING POINTS
- Check the points listed above together with the following points :
t5IFDPSSFDUXJOEJOHPGUIFCFMU
t$POEJUJPOPGUIFSFFMHVBSET
t3PMMFSMPDLJOHNFDIBOJTNXIFOUIFTUSBQJTHJWFOBTIBSQUVH
NOTE : After an accident, replace the seat belt.
Under no circumstances should you use the lift truck if the seat belt is faulty (fixing, locking, it has cuts or tears, etc). Repair or replace the seat belt immediately.
E3/2
7
2
E3/4
8
E3/3
3
4 6
6
4
5
647448
(20/05/2015)