Manitou 100 SC-2, Руководство оператора

Страница: 85 / 104

3-13
A4 - Braking
CHECK
- Perform a translation and then release the control.
- No jerkiness, sudden and unusual translation or noise should be noted.
- In slow speed, the braking distance should be no more than 1.5 metres on a hard flat
surface.
A5 - Condition of the wheels and tyres
CHECK
- Check the condition of the tyres to discern any cuts, tears, protuberances, wear spots,
etc... on the tyres.
A6 - Tightness of the wheel nuts
CHECK
- Check the tightness of the wheel nuts.
Failure to comply with this instruction may result in damage to or breakage of the
wheel pins and deformation of the wheels.
A7 - Hydraulic oil level
CHECK
- It is essential to keep the hydraulic oil at a correct level for the machine to operate
correctly. The wrong level of oil can damage the hydraulic components. Daily checks
enable you to note any variation in oil level that could indicate the presence of
problems in the hydraulic system.
- Remarks: perform this procedure with the platform in the folded position and with the
engine switched off.
- Visually check the sight glass located on the side of the hydraulic oil reservoir.
- Result: the hydraulic oil level must be less than 5cm from the top of the sight glass.
- Add oil if necessary.
A8 - Condition of the joystick bellows gaskets
CHECK
- For this operation, climb into the basket when the engine is switched off.
- Check that the joysticks’ rubber bellows are in good condition by moving them as if
you were making a manoeuvre.
- The bellows must not show any cracking or fissures; otherwise there is a risk that water
penetration may prevent the machine from operating correctly.
A7
A6
647367
(01/03/2017)
100/120
SC-2
/ 140
SC