Page 11
Version 2023-02-14
Volume control damper - VCDM
TPM 167/23
VI. ASSEMBLY, ATTENDANCE AND MAINTENANCE
Assembly
■
Assembly, maintenance and damper function check can
be done only by qualified and trained person, i.e.
“AUTHORIZED PERSON” according to the manufacturer
documentation. All works done on the fire dampers must
be done according international and local norms and laws.
■
All effective safety standards and directives must be
observed during damper assembly.
Entry into service and revisions
■
Before entering the dampers into operation after
assembly and after sequential revisions, checks and
functionality tests. After entering into operation, these
revisions must be done according to requirement set by
national regulations.
■
In case that dampers are found unable to serve for their
function for any cause, it must be clearly marked. The
operator is obliged to ensure that the damper is put into
condition in which it is ready for function.
Spare parts
■
Spare parts are supplied only on basis of an order.
VII. ORDERING INFORMATION
Ordering key
VCDM 200x200 - .01
EXAMPLE:
VCDM 200x200 - .01
- 200x200-damper size, .01-damper design
design
size AxB
Dampers design
Additional digit
Manual control
.01