Ref.: WB-VL-SM Ver.1 3.doc
19
4.1.2.
HCV MODELS
Both LCV calibration & HCV calibration should be performed
separately. “Car cal. data not available” / “Truck cal. data not
available
” message will be displayed in WHEEL RUN screen if
Calibration data is not available
Pre calibration (Applicable for Factory & Authorized Engineer)
Following sub options will be provided in
WEIGHT CALIBRATION
screen as
shown below. Once selected, following sub options will be provided in
WEIGHT CALIBRATION
screen as shown below:
Fig. 31
Select the Car or Truck mode to proceed with the Weight calibration.
SPINDLE ZERO
By default,
SPINDLE ZERO
will be highlighted. Press
key to proceed with
Spindle zero calibration.
Fig. 32
Remove Wheel, Wheel seating cone & Lock nut from shaft if already mounted.
Press
key twice to run the Empty shaft. SA & SB Sensor values will be
displayed (in millivolts) in the respective window (limit: 30mV) including RPM
and the system will go to
RIM PARAMETERS
screen.
Fig. 33
Mount the wheel.
Содержание LX WB-VL-65 DSP
