Ref.: MEL-WA(3D HCV) - OM Ver.1.7
2
2. SAFETY
Thoroughly read all Safety labels and Manual instructions before installing, operating and
maintaining the Wheel aligner. They are provided to remind the operator to exercise extreme
care while performing wheel alignment with this product to prevent personal injury and property
damage. Replace any label unreadable or missing on the Wheel aligner. Refer Part No. given
for each Labels for ordering.
It is the
Operator‟s responsibility to have sufficient knowledge on the vehicle to be aligned and
to use proper service methods and perform wheel alignment in an appropriate and acceptable
manner that does not endanger safety of the Operator / others in the work area or the
equipment or vehicle being serviced.
Always keep the Manual in a prominent place for quick reference.
Injury to personnel and damage to property incurred due to non-compliance with these safety
instructions are not covered by the product liability regulations.
SYMBOLS
Failure to comply with instructions could result in personal injury
Failure to comply with instructions could result in property damage
Important information
2.1.
INTENDED USE
Use the Aligner as described in this Operating manual only.
Use only the Accessories recommended by the manufacturer.
Carryout alignment by positioning the vehicle to be aligned on the Alignment pit /
Alignment lift only.
2.2.
SAFETY INSTRUCTIONS FOR COMMISSIONING
1.
Only Authorized service personnel are allowed to install and commission the
Wheel aligner.
2.
Aligner should not be installed outdoors or in moist rooms (nearer to car
washing).
3.
To reduce the risk of fire, the equipment should not be installed at hazardous
locations or in the vicinity of explosives or flammable liquids.
4.
The Aligner should be installed with adequate ventilation in case of working on
vehicles with internal
combustion engines.
5.
Keep the System away from high capacity Transformers, Electric motors and
other strong magnetic fields.
6.
Use proper handling tools while installation of Aligner for safety of equipment.
7.
The electrical main supply to the Aligner must be connected through a CE
certified Two pole, Type C, 6A MCB (Miniature Circuit Breaker). Proper Earthing
must be provided.
8.
If an Extension power cord is required, a cord with correct rating equal to or more
than that of the equipment should be used.
9.
Care should be taken to route the Power mains cord properly so that it is not
tipped over or pulled.
10. The Cables from both the vertical columns should be routed through the cable
duct and connected to the Cabinet.
11. During installation of Third party products (like Desktop computer, Monitor,
Printer, Keyboard, Mouse, Speakers, Operating system software etc.) follow the
safety instructions provided in the respective OEM
‟s Installation document.
12. Ensure the disposal of ecologically harmful substances in accordance with the
appropriate regulations.
Содержание JUMBO HCV
Страница 1: ...3D WHEEL ALIGNER HCV model OPERATING MANUAL Ver 1 7...
Страница 14: ...Ref MEL WA 3D HCV OM Ver 1 7 9...
Страница 15: ...Ref MEL WA 3D HCV OM Ver 1 7 10 Drive Through model...
