MANATEC Fox 3D Smart Mobile PT, Руководство по обслуживанию

Страница: 60 / 104

Ref.: 3DWA - SM Ver.1.8
57
7. CALIBRATION
This feature is protected with service password and should be used only by authorised
Service personnel
Calibration is a very important function. During this process, the Calibration kit should
not be jerked or moved
Even though the system is perfectly calibrated at Factory, it can be ensured by
calibrating the system again at customer premises before commissioning
Ensure Sunlight / external light source does not fall directly on the Target plate during
Calibration / Alignment, which may affect the accuracy of readings
In AVH model, Horizontal beam should be rested at home position during Calibration
If the alignment readings obtained for all vehicles are error prone, then it is advisable to check
calibration. Calibration is to check the raw data transmitted by sensing devices. The procedure
for checking the calibration is as follows. Following options are available in
Calibration once
selected from Settings screen:
Fig. 95
7.1. BEAM INSTALLATION
This featured is used to avoid field calibration at the time of installation. 3D Aligner is
perfectly calibrated in the factory using high precision calibration setup & highly trained
personnel. However to ensure the same accuracy during installation, a Dual axis
sensor is used in the horizontal beam. After mounting the Horizontal beam on the
Vertical column, select the
INSTALLATION from Calibration menu & try to achieve
Green color values for both Z axis (Vertical column) and Y Axis (Horizontal beam) by
leveling the vertical column using shims.
Fig. 96
Z axis
Y axis