MANATEC Fox 3D Smart Mobile PT, Руководство по обслуживанию

Страница: 38 / 104

Ref.: 3DWA - SM Ver.1.8
35
5. DESCRIPTION OF MAIN PARTS
5.1. CAMERA BEAM / COLUMN
For PT / VH / AVH models
The Horizontal beam consists of the Camera-LH, Camera-RH, IR LED board-LH, IR
LED board-RH and LED Driver & Hub board assemblies. Connect the following two
cables coming from Horizontal beam as given below:

+12V supply cable to the Interface box

USB cable to the USB port of PC
1
3
2
8
5
6
7
4
9
10
11
12
Fig. 37
Sl.No. Description Sl.No. Description
1 Camera-LH 7 Camera plate
2 Camera-RH 8 LED Driver & Hub board
3 IR LED board 9 Hub board plate
4 Camera locator block 10 Hub board cover
5 Camera cover 11 Hub board cover clamp
6 Camera cover back plate 12 BSM connector tube
For DT / In-Lift models
The Camera-LH & Camera-RH are fixed to the respective vertical columns.
5.1.1. CAMERA (LH & RH)
Camera is used to acquire the image reflected from Target plate.
The Camera used in 3D Wheel aligner is a high resolution SI (Scientific
Imaging) camera with USB port. Left side Camera is mounted in such a way
that the image viewed on the Monitor will be upside right (Straight picture).
Right side Camera is mounted in inverted position. Hence the image will be
upside down. The Camera is integrated with IR Filter to block the ambient
light and allows only the IR lights.
The camera and Lens along with IR filters are calibrated for linearization at
factory using special purpose equipment.
It is set at factory itself and It should
not be opened or dismantle the lens from the Camera . If it is dismantled, then
the angle and distance measurement will go wrong and the entire wheel
alignment/measurement will be improper. In case of Camera replacement, the
entire camera setup (with factory calibrated) should to be replaced.
Both the LH & RH Camera are routed through LED Driver & Hub board and
connected to PC.