MANATEC Fox 3D Smart Mobile PT, Руководство по обслуживанию

Страница: 31 / 104

Ref.: 3DWA - SM Ver.1.8
28
4.2.2. WALL MOUNTING BRACKET
Wall (Brick or concrete) has to be ensured for its strength to hold
anchor bolt. The entire beam load will act on anchor bolts only
1. After evaluating the space available in the alignment bay, decide the
Wheel base (B), Distance between Camera to Rotary plate centre (D)
and Camera height that can be accommodated as per the table given
below:
B D
H
F
ro
n
t
Wh
e
e
l
R
e
a
r
Wh
e
e
l
(m
a
x
.
W
.B
)
Fig. 26
Wheel
base
(in mm) (B)
Distance between
Camera & Rotary plate
centre
(in mm) (D)
Camera
height
(in mm)
Required Tilt
angle to be set in
Wall mount
bracket
Required Height to be maintained
between Wall mount bracket
bottom & Ground to meet the
Camera height (in mm) (H)
4000 2000 1000 12° 787
4000 2000
1000
15°
792
1100 892
3900 2100 1200 992
4000 2000 1300
19°
1099
3800 2200 1400 1199
3700 2300 1500 1299
3800 2200 1600
22°
1405
3700 2300 1700 1505
3500 2500 1800 1605
2. Now, tilt the Beam mounting plate to match its locking hole with the
respective hole (punched with angle) in bracket and lock the position by
inserting Allen screw (M6x25) and fix it using Plain washer & Nut at inner
side of bracket.
3. After assembling the Wall mount bracket with required tilt, mark the
centre line of the Pit and extend the line up to wall.
4. Make a mark at 2mtr from the Left and Right Rotary plates centre.
5. Place the Bracket centre on the centre line to the alignment Pit/Lift along
the 2mtr line. Use two plumbs to create reference point to measure the
physical distance.
6. Place the Wall mount bracket on the wall perpendicular to pit by
maintaining the decided height & Distance between Camera to Rotary
plate centre. Use Tube level at the tapered edges of Beam mounting
plate to ensure its horizontality.
7. Mark 4 holes on the wall & drill the holes using Drilling machine.
8. Fix the Anchor bolt by using hammer.
9. Mount the Wall mount bracket on wall and tighten the nuts.