EYLESSO42
Congratulations on your purchase of the Wireless keypad
Model KEYLESSO42. The keypad
works with the Manaras® receivers. In this package, you will find a wireless keypad
with 1.5V
AAA battery
and screws.
The keypad transmitter can operate up to 4 receiver
units, that also
means one keypad
transmitter can operate up to 4 garage door openers.
Same PIN will be used for all doors. The
factory default password is [0 0 0 0].
To operate door 1, you will enter [0 0 0 0][#][1]
To operate door 2, you will enter [0 0 0 0][#][2]
To operate door 3, you will enter [0 0 0 0][#][3]
To operate door 4, you will enter [0 0 0 0][#][4]
To program the
keypad transmitter into the receiver, you must
decide which door you need to
operate. If you only have one receiver, we suggest you to use door 1. i.e. [0 0 0 0][#][1]. Follow
the
instructions below to program the keypad transmitter.
Follow the instructions below to change the PIN.
To change your PIN:
1. Enter the current PIN, (factory default PIN 0 0 0 0), press * .
2. Enter new 4 to 6 digit PIN, press * .
3. Enter new PIN again, press * .
For example, if you are changing the PIN number from 0000 to 123456,
enter the following
sequence, 0000, *, 123456, * , 123456, * .
If confirmed, the balcklit LED flashes and the unit emits
a long beep.
One 1.5
volt AAA type
battery
(included).
It is time to change the battery
when the backlight no longer
appears.
The Wireless kepad
is approved by the FCC and it complies with
FCC
MODEL K
User Manual
Brand name:Manaras
FCC ID:X7OKEYLESSO42
IC:8860A-KEYLESSO42
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
