Man D 2866 LUE 602, Руководство по ремонту

Страница: 36 / 174

3
4
5
6
Checking and repairing fuel injectors
34
Disassembling fuel injectors
Fig. 3
Insert injector assembly (the inlet orifice facing
downwards) into the clamping device and hold in a
vice.
Remove union nut and take out nozzle body, inter-
mediate washer, pressure pin, compression spring
and shim.
Take pressure pipe neck out of holder.
Repairing fuel injectors
Fig. 4
Clean interior of injection body
À
with a small
wooden stick and petrol or Diesel fuel.
Clean nozzle needle
Á
with a clean cloth.
Clean coked nozzle needle surface on lathe with a
piece of wood (not too hard) dipped into oil.
Note:
To prevent corrosion, do not touch lapped
faces of nozzle needle with the fingers.
The needle and injection nozzle are
matched to each other and must not be
interchanged.
Check cleaned parts for wear and damage, replac-
ing them if necessary. De-grease new parts.
Assembling fuel injectors
Fig. 5
Insert pressure pipe neck into clamping device.
Insert shim and compression spring.
Fig. 6
Check intermediate piece for wear.
Insert pressure pin and intermediate washer.
1
2