GiSMo
GSM/GPRS Programmable
Communicator
21 Hubert Mathew Road, Illiondale, 1609
Tel +27 11 452 4737 Fax +27 11 452 4738
www.mami.co.za
M000153
The GiSMo 2 is a multi-purpose GSM unit used for monitoring and controlling devices via SMS and Mobile network
One time programmable missed call or one time pin
2000 Names & Numbers (intercom)
Non-restore time
Programmable via SMS or USB
Programmable: Trigger times per input
Event logging onboard (offline version) or web(online version)
Input names
Reverse polarity protection (24V)
Input action (Call, SMS, trigger output, GPRS)
Access control time for missed call
Input Delay (positive and negative)
Auto airtime check and recharge commands
GiSMo
Start up
For ease of setup we recommend using a USB cable(GiSMo4) and make use of PC software to program.
Please make sure that the SIM card in use does not have a security PIN number. This can be disabled by putting the SIM
card in a mobile phone and removing the PIN request. Insert the SIM card as show in Figure 3.
The GiSMo must have a power supply that can handle up to 2A spikes form SMS and GPRS usage. It is therefore
recommended to connect to a battery or good power supply.
The GiSMo is operational when the green LED flashes slowly (1 flash every 2seconds (offline version) or 1 flash every 3
seconds (online version)
Any problem with the SIM card (such as incorrect insertion or PIN number) will be indicated by the RED LED turning on
IMPORTANT!
All numbers need to contain the international dialing code (27 for South Africa) without a l or 0 eg: 27821234567 is correct
SMS Programming
ž
All commands are confirmed with a reply SMS to the person sending the message or to the status number (if set)
ž
All SMS commands start with an asterisk ‘*’ followed by a 4 alphanumeric password, eg. *2222 2222 is the default password
ž
All commands and settings are converted to upper case.
Resetting
ž
Hold down both buttons and apply power, continue to hold the buttons for 10 seconds and the green and red LEDs will begin to flash
alternately, release the button and wait for approx 4minutes while the memory is erased.
Hardware Features:
3 inputs
2 voltage free relay outputs
Built-in lead acid charger
Open Serial Port (optional-GPRS)
Built-in Radio Receiver (optional)
Compatible Accessories:
Intercom 2 button home intercom
Topo/SLIM remote control relay activation
