SkyRaider DS10CTEC User Manual
March 17, 2019
SkyRaider DS10CTEC User Manual
Page 116
If you have enabled the
Dark Field
Corrections
for this session (
Dark Fields
are
stored directly in the
SkyRaider Camera
and will be deleted when the camera is
turned off), the
SkyRaider
will automatically apply the best
Dark Field Correction
to your image when
Dark Field Correction
is
enabled
.
Trigger Mode
Trigger Mode
is used mainly for exposures over 5 seconds (Deep Sky Objects). It is
selected by checking the
Trigger Mode Radial Button
. This mode does not require
the Green Rectangle for exposure control. But rather allows you to take a
Single
image, or continuously
Loop
images from the
SkyRaider DS10CTEC
.
➢
You have two methods of setting your exposure to a large value:
o
You can
Click
in the
Time Unit Box
of choice and enter in an
amount (i.e.
30 seconds
) using your Keyboard.
o
You can
Click
on the
up
or
down
arrow in the
Time Unit Box
of
choice to move the exposure time to your required value (
30
seconds).
➢
Click
on the
Single Button
to a take a single exposure to see if the image
of the object is close to the brightness you need.
➢
If you are satisfied with the single image, then
Click
on the
Loop Button
to
have the SkyRaider DS10CTEC continuously take images at the entered
exposure value (it will change its name to
Stop
, so you can again
Click
on
the button to stop the Looping).
To capture a sequence of images using the Mallincam
SkyRaider DS10CTEC
,
there is are a series of command controls available for you.
