XAM 25
ENG
Although your vehicle has been thoroughly checked before delivery, problems may occur during operation.
The fault detection chart below shows quick and easy test methods that you can use to perform a quick check
yourself. If your vehicle needs repairs, please contact your dealer who has the necessary tools, expertise and
experience to service your vehicle properly.
ERROR
ERROR CODE
CAUSE
MASSNAHME
When the bike is switched
on, "READY" does not light
up.
Side stand switch defective
Replacing the side stand switch
Brake switch fault
Replace brake switch
The ignition lock is defective
or the key is not in position
Insert the key correctly,
Replace ignition lock
The vehicle is switched on
and the "READY" indicator
lights up, but the motor does
not work.
10
20
Battery fault
Check the cable or change the
battery
30
50
Controller fault
Motzor fault
Throttle grip fault
Check the plug and the cable of
the throttle grip or change it if
necessary.
Brake switch fault
Replace the brake switch
Failure of the speed control
or the maximum speed is
lower.
Battery level only 2 bars
If the battery capacity is less
than 20%, it switches to turtle
mode.
Fully charge the battery
11 21
The temperature of the
battery is higher than 60 °C
or lower than 0 °C.
Let the battery cool down,
warm up
21
The temperature of the
controller is higher than
90 °C.
wait until the temperature is
below the limit value
31
The engine temperature is
higher than 120 °C
wait until the temperature is
below the limit value
50
Throttle error
Visit a dealer to replace the gas
regulator
FAULT DETECTION
