MAKSIWA CBC.T, Инструкция по эксплуатации

Страница: 13 / 80

13
3 Installation
3.2 Assembling Detached Parts
1. For transport the tape coil support can
be detached from the machine.
2. Fix the plate A to the machine table
with the 2 screws D.
3. Place the tape coil support B on plate
A placing the nuts in their correct
position then tighten the screw C.
3.3 Electrical Connections
WARNING: WORK ON ELECTRICAL FITTINGS MAY ONLY BE CARRIED OUT BY QUALIFIED
PERSON. SERIOUS INJURY MAY OCCURRED WHEN LACK OF ATTENTION.
• Check that the voltage and the power frequency available correspond on the machine nameplate
on the machine frame.
1. Open the wiring box to connect the cables as shown.
2. Connection 220/1, cable with 3 wires (2-line, 1 earth).
The 1 phase to L1, L2, Earth to PE.
3. Use a cable adequate for the total power installed.
4. Close the wiring box.
• Check the direction of rotation:
1. Turn on the machine, then press “Conveyer” on the control
panel.
2. Check whether direction is correct. If the direction is not correct, press emergency stop bottom
immediately.
3. Turn off the power and exchange two wires (choose two from L1, L2, L3 to exchange)
4. Repeat step one again and make sure the direction is correct.
Never
connect the neutral to the earth and L1, L2, L3.
WARNING:
a wrong connection (for instance inverting a phase with the neutral or not connecting
the neutral) can caused damages irreparably such as heating elements and motors.