Makita XBU02, Руководство по ремонту

Страница: 3 / 13

P 3/ 13
R
epair
[3] DISASSEMBLY/ASSEEMBLY
(2) Separate Motor housing from Housing set L. (
Fig. 2
)
(3) Remove M5 Coned disc spring hex nut from the rotor shaft and remove Fan 110. ( Fig. 3 )
Fig. 2
Fig. 3
While paying attention not to loosen Switch section in Handle portion,
separate Motor housing section from Housing set L.
2. Lock Fan 110 with the grip of plastic hammer,
and then remove M5 Coned disc spring hex nut
from the rotor shaft by turning it counterclockwise
with the impact driver.
4. Fan 110 can be
removed using 1R045,
if it is difficult to
remove by hand.
[3] -1. Fan 110, Rotor (cont.)
DISASSEMBLING
Switch section
Motor housing Housing set L
Fan 110 is removed from
this side in the next step.
Fan 110
Flat washer 5
Socket bit 8-55
55 mm
8 mm
Grip of plastic
hammer
M5 Coned disc
spring hex nut
1. Attach Socket bit 8-55 to an impact driver
to remove M5 Coned disc spring hex nut.
Fan 110
3. Remove Fan
110 by hand.
Note:
Make sure not to
lose Flat washer 5.
1R045
M5 Coned disc spring hex nut