5-5
Brush holder cover
5-5-1
Disassembling
5-5-2
Assembling
5-6
Assembling of Handle set
Fig. 5-6-1
Fig. 5-5-1-2
Fig. 5-5-1-1
[1] Remove 4x14 Tapping screw from
left/ right side of machine.
[2] Open Brush holder cover R.
(In the same way, open Brush holder cover L.
Remove one of the hinge of
Brush holder cover R.
(In the same way, remove
the other hinge. After that,
remove Brush holder cover L.)
Fig. 5-5-1-3
Assemble by reversing the disassembly procedure.
[1] Tighten two 4x18 Tapping screws to fasten
Handle R to Handle L .
4x18 Tapping screw
4x18 Tapping screw
Gap between Handle R and Handle L
[2] While holding Handle R and Handle L by hands to
disappear the gap, tighten four 5x30 Tapping screws.
5x30 Tapping screws (4 pcs.:
that fastens Handle R and
Handle L to Motor housing)
Fig. 5-6-2
20 / 25
