MakerBot Replicator, Руководство пользователя

Страница: 14 / 61

GettinG started 14
sEtting up thE MakErbOt rEpLiCatOr
Locate and unwrap the Smart Extruder
and press it against the back of the extruder
carriage, with the connector pins facing
the extruder carriage. Magnets will lock
the Smart Extruder into place.
1 instaLL thE MakErbOt rEpLiCatOr sMart ExtrudEr
2a. Locate the MakerBot PLA Filament spool
and remove it from its plastic bag.
2b. Grasp the back section of the frame of
the MakerBot Replicator and pull upwards to
open the filament drawer. open the drawer
all the way.
2 instaLL thE spOOL Of MakErbOt pLa fiLaMEnt
note:
If you need to install the
Smart Extruder again at any time,
go to the control panel and select
utilities > system tools > attach
smart Extruder.
i
Caution:
Never remove the MakerBot Replicator Smart Extruder from your MakerBot
Replicator during or immediately after printing. Always allow the Smart Extruder to cool
completely before removing it from the 3D printer.