16.8.2020
Update DinoPark to v2 Firmware - MakeProAudio MediaWiki
https://wiki.makeproaudio.com/index.php/Update_DinoPark_to_v2_Firmware
4/5
Now connect the Text Display via USB to your Windows PC.
Open a command prompt and navigate to your
DinoPark_Update
directory.
Read from the Windows Device Manager under which COM port the Text Display can be reached. It should appear there with an
entry like "USB Serial Port (COM7)". Alternatively, you can use the command
mode
in the command prompt. Now start the batch
file
Display-Update.bat
from the command prompt and pass the COM port you just determined as parameter, e.g. like this
Display-Update.bat COM7
During the update, the display turns off and on again, which is perfectly normal. Wait until the update is completed with the
following message:
DinoPark Display Updater SUCCESS!
Now disconnect the USB cable from the text display and close the housing:
1. Carefully pull the two side rails upwards again, so that you can push the removed blind tile back in.
2. Replace the two upper screws and tighten them.
Done! You can now switch on and use your DinoPark again.
There is a new Installer for VSTi and Standalone Editors available.
New in v1.2 is
A set of Standalone Editor Applications. These can be started per Plugin as an independant application, not depending on any
DAW with VSTi Host.
VSTis and Standalone Editors for FMAGIA, LightWave and Drums'n'Bass
The Mac version now also supports macOS 10.15 "Catalina"
PLEASE NOTE that in order for these Editors in v1.2 to run, DinoPark FirmWare Version 2 is required!
The Installers are available for download here:
For
Windows
32
Bit:
For
Windows
64
Bit:
Download and install the new VSTi/Standalone Editors in v1.2
