16.8.2020
Update DinoPark to v2 Firmware - MakeProAudio MediaWiki
https://wiki.makeproaudio.com/index.php/Update_DinoPark_to_v2_Firmware
3/5
DinoPark-Update-Step1.bat
DinoPark-Update-Step2.bat
Display-Update.bat
DinoPark has to be updated in two steps. There are two batch files (DinoPark-Update-Step1.bat and DinoPark-Update-Step2.bat)
which you launch to start the respective update step.
Connect DinoPark via USB to your Windows PC, supply it with 12V and switch it on. It should now show up as a MIDI Device
"DinoPark" in your device manager. Open a command prompt, navigate to your
DinoPark_Update
directory and start
DinoPark-
Update-Step1.bat
. Wait until the first step is finished with the following message:
DinoPark Updater Step1 SUCCESS!
Please look up the newly assigned COM port number and start Step2.
After a successful Step 1, your DinoPark will no longer appear as a MIDI Device but as a serial device (a COM port). Read from the
Windows Device Manager under which COM port DinoPark can be reached. After executing step 1, it should appear there with an
entry like "USB Serial Port (COM8)". Alternatively, you can use the command
mode
in the command prompt. Now start the batch
file "
DinoPark-Update-Step2.bat
" and pass the COM port just determined as parameter, e.g. like this
DinoPark-Update-Step2.bat COM8
This process may take a while, do not interrupt it under any circumstances! Wait until the update is finished with this message:
DinoPark Updater Step2 and Update SUCCESS!
Please power-cycle your DinoPark and enjoy v2 Firmware!
You're done. Restart your DinoPark.
To update the firmware of the DinoPark's text display, you have to connect it directly to your Windows PC. To do this, switch off
your DinoPark, remove the USB cable and the power supply.
You do not have to disassemble the DinoPark completely to get to the USB port of the Text Display. Normally, the following
procedure should be sufficient:
1. Unscrew the two screws on the upper edge of the Text Display.
2. Carefully pull up the two upper side rails a little bit, just enough to pull out the first blind tile (see photo).
Update the DinoPark
Step 1
Step 2
Update the Text Display
