D�.�.�_KD���������
Place the bracket on the baseplate. Carefully and correctly
line up the holes on the bracket and the baseplate as shown.
The baseplate comes with protective film on both sides to protect
it from scratches. Peel off the film before using the baseplate.
1
Make sure you remove
the film on both sides!
One side of the baseplate has a △ mark. Make that
side face up. Install the three legs.
2
3
The side with the △
mark should face up!
Lay Halocode on the bracket with its Micro USB port pointing at the △ mark on the baseplate. Fasten Halocode and the bracket to the baseplate with screws and studs.
4
The Micro USB port on
Halocode should point
at the △ mark on the
baseplate.
Do the same with the rest
of the screws and studs.
Push against the screw
with your finger.
�
Tighten the stud clockwise.
�
Building Instructions
