8
PHONOGENE Panel Controls (cont’d)
8. Vari-Speed CV Input: bipolar speed and direction control where 0V stops playback, positive control signal increases
playback speed in forward direction, negative control signal increases playback speed in reverse direction. Range +/-4V.
9. Vari-Speed Bipolar Panel Control: manual bipolar speed and direction control. When set to 12:00, playback is
stopped, turning Clockwise from 12:00 increases playback speed in forward direction, turning Counter Clockwise from
12:00 increases playback speed in reverse direction.
10. Vari-Speed CV Input attenuverter: bipolar attenuator for Vari-Speed CV Input.
11. Organize CV Input: unipolar control signal input which selects next Splice to be played. he currently selected Splice
plays to end before the next Splice is selected. The Vari-Speed and Splice Indicator LEDs (6 & 7 ) flashes whenever
this control ends a new Splice. Range 0V to +5V.
12. Organize CV Input Attenuator: unipolar attenuator for Organize CV Input.
13. Organize Panel Control: manual unipolar control which selects next Splice to be played. The Vari-Speed and
Splice Indicator LEDs (6 & 7 ) flashes whenever this control ends a new Splice.
14. Play Pulse Input: at each rising edge signal applied to Play Pulse Input, PHONOGENE triggers playback. At end of loop or
Splice, PHONOGENE looks at Play Pulse Input. If High, it plays again. If Low, PHONOGENE does not play. This Input is
normalized to be High. So with nothing patched to Play Pulse Input, PHONOGENE plays continuously. Sees only rising
edge of signal. Needs at least 1.5V trigger signal to operate.
15. Record Pulse Input: toggles record on/off. When recording from a cleared buffer, the first record cycle sets the record
length, so be sure to perform the Erase Routine to achieve a new recording. Sees only rising edge of signal. Needs at
least 1.5V trigger signal to operate.
16. Record button: manual, momentary button to toggle record on/ off.
17. Record LED indicator: when lighted, PHONOGENE is recording. When not lighted, PHONOGENE is not recording. When
flashing, PHONOGENE has entered the Erase Routine.
18. Splice Button: pushing drops splice marker on loop. When loop is Organized, the splices (resulting audio
segments) are re-arranged according to the Organize control voltage as the PHONOGENE plays whichever splice is
selected by Organize parameter. Since splices may be erased, this process is nondestructive. Holding this button for 3
seconds enters Erase Routine (Rec LED flashes to indicate the Erase Routine).
19. Splice Pulse Input: input for using external signal to splice loop. Sees only rising edge of signal. Needs at least 1.5V
trigger signal to operate.
20. End Of Splice Output: outputs a short 4 ms pulse at the end of each splice. In the absence of Splices, EOS reflects end of
loop, which is always present when a recording has been made.
21. End Of Splice LED indicator: lights to give visual feedback of End of Splice.