Major tech MT1885, Инструкция по эксплуатации, Страница: 9 / 20

9
6.3. AC/DC CURRENT MEASUREMENTS
CAUTION: Do not make 10A current measurements for longer than 30
seconds. Exceeding 30 seconds may cause damage to the
meter and/or the test leads.
1. Insert the black test lead banana plug into
the negative COM jack.
2. For current measurements up to 6000µA
AC/DC, set the function switch to the µA
position and insert the red test lead banana
plug into the
µA/mA jack, press mode
button to select AC or DC.
3. For current measurements up to 600mA DC,
set the function switch to the mA position
and insert the red test lead banana plug into
the
µA/mA jack, press mode button to
select AC or DC
4. For current measurements up to 10A DC, set
the function switch to the 10A position and
insert the red test lead banana plug into the
10A jack, press mode button to select AC or
DC.
5. Remove power from the circuit under test,
then open up the circuit at the point where
you wish to measure current.
6. Touch the black test probe tip to the
negative side of the circuit. Touch the red
test probe tip to the positive side of the
circuit.
7. Apply power to the circuit.
8. Read the current on the display.