Maiwe MIEN5208 Series, Руководство пользователя

Страница: 12 / 39

MIEN5208 Series Managed Industrial Ethernet Switch
- 6 -
network connection
blinking Port has network activity
off
The port does not have a valid network
connection
Ethernet RJ45 port status LED
Each Ethernet RJ45 port has two indicators, a yellow light for the port rate
indicator and a green light for the port connection status indicator.
10/100M
（
Yellow light
）
On 100M
（
100Base-TX
）
off 10Mworking status
（
10Base-T
）
LINK/ACT
（
Green light
）
on
The port has established an active
network connection
blinking Port has network activity
off
The port does not have a valid network
connection
3.1.3. Hardware installation
Din-rail installation
If the MIEN5208 series switch needs to be snapped onto the DIN rail, the
DIN rail should be checked for installation before installation. Includes the
following 2 items:
Weather the DIN rail fixed and strong, whether other equipment is installed
on the DIN rail, and whether there is enough space for installing the switch.
Weather there is a power supply suitable for the operation of this switch on
the DIN rail?
After selecting the installation location of the switch, install the switch to
the DIN rail as follows:
Insert the upper part of the DIN rail into the card slot of the circlip on the
upper part of the DIN rail connector. Rotate the device slightly downward on
the upper panel of the switch and rotate the device as shown in Figure 3-5 A.
As shown in Figure B, insert the DIN rail into the DIN rail connector and
confirm that the switch is securely mounted to the DIN rail.
.