Maipu SM6600-04-MF, Руководство по установке

Страница: 63 / 174

MyPower S6600 Series Routing Switch Installation Manual
Installation Preparations
copyright
©
2015 Maipu All rights reserved. 11
� The switch does not carry Ethernet twisted pair. Please prepare the desired
cables by self in advance.
4.2.2 4.2.2 4.2.2 4.2.2 Access
Access
Access Access Network
Network
Network Network via
via
via via LC
LC
LC LC Fiber
Fiber
Fiber Fiber
For the SFP, SFP+, LC optical port of the switch, you can use the LC fiber to
connect the network. Before connecting fiber, first install the optical module to
the switch and then insert the fiber connector to the optical module. The
appearance of the general LC fiber connector is as shown in the following figure.
F
F F
F
I G U R E
I G U R E I G U R E
I G U R E
4
4 4
4 1 0
1 0 1 0
1 0 L C
L C L C
L C
F I B E R
F I B E R F I B E R
F I B E R C O N N E C T O R
C O N N E C T O R C O N N E C T O R
C O N N E C T O R
Install Install Install Install Optical Optical Optical Optical Module Module Module Module
The installation processes of the SFP module, SFP+ module, and LC QSFP+
module are similar. The following takes the SFP module as an example. The steps
are as follows:
� When installing the SFP module, do not use the hands to touch the gold-finger
of the SFP module directly.
� The TX wire should connect to the RX wire of the peer device; the RX wire
should connected to the TX wire of the peer device.
Step 1: Wear the anti-static wrist and confirm that the anti-static wrist is well contacted with the
skin and well-grounded.
Step 2: Get the SFP module out from the packing box. The diagram of the SFP module is as shown
in Figure 4-11. Use the hands to hold the two sides of the SFP module and push it into the
interface slot of the switch horizontally until the SFP module is close-contact with the slot
(you can feel that the shrapnel at the top and bottom of the SFP module stuck the interface