Maidaid Halcyon Evolution 2035WS, Инструкция по установке и эксплуатации

Страница: 13 / 17

INSTRUCTION MANUAL FOR DISHWASHERS
Page 10 of 14
UK
4.13 Machine with external water softener
In machines equipped with an external water softener, after a certain number of cycles, the display will
show the message
‘SERVICE’. This indicates that the resins of the external softener must be
regenerated.
This signal remains even when the machine is off. To eliminate it, press and hold,
for at least five
seconds, with the machine off and the door open, the START key (3) .
4.14 End of shift
•
At the end of the day always drain the machine as described in the section Machine draining.
•
Disconnect the power supply by means of the main switch and close the external water cock.
•
Perform routine maintenance and clean the machine as described in the section Maintenance.
•
If possible, leave the door ajar to prevent bad odours building up inside the machine.
Chap 5 MAINTENANCE
5.1 General rules
Before doing any maintenance, completely drain out all water, shut off the power
supply and close the water supply cock.
Do not use water under pressure - it can damage the electrical equipment.
Only wash the body panelling when it is cold, using only product specifically designed for steel.
If there is a risk of ice forming, drain the water from the boiler and wash pump.
5.2 Cleaning
To keep the machine in good working order, it must be maintained regularly as explained below. We
recommend periodically running a sanitising treatment with suitable non-corrosive commercial
products.
5.3 Cleaning the filter unit
Run this procedure at the end of the day or when you see the filters are dirty:
1. Remove and clean the baskets.
2. Empty out the tub as explained in “Machine draining”.
3. Remove and carefully clean all the filters.
4. Do not use abrasive products to clean the tub.
5. Restore all removed parts when finished.
5.4 Cleaning the arms
The wash and rinse arms are easily removed in order to clean their nozzles and prevent
blockage/encrustations.
Proceed as follows (
Fig.9 ):
•
Undo nut R and remove the arms.
•
Wash all parts under a jet of running water and clean the nozzles thoroughly, using a toothpick or
pointed tool if necessary.
•
Clean the arm rotation pins inside the machine and the wash and rinse water drainage area.
•
Restore the arms and check that they rotate freely.