Maidaid Halcyon Evolution 2035WS, Инструкция по установке и эксплуатации

Страница: 11 / 17

INSTRUCTION MANUAL FOR DISHWASHERS
Page 8 of 14
4.6 Description of special programmes
GLASSES (PLATES) wash programme .
The Glasses programme is suited for washing glasses of any shape or type.
This programme washes with a low rinse temperature and requires a long drying
time.
ACT wash programme.
The Intensive programme is suited for washing very dirty, even encrusted dishes
that have been left for some time. The programme includes 2 washes and 2 rinses.
STEEL wash programme.
The cutlery wash programme is suited for washing forks, spoons, knives and all
sorts of other cutlery. This wash programme is longer than the others.
GREEN Wash programme.
The ECO wash programme reduces energy consumption by washing at lower
temperatures and with reduced water consumption than normal wash programmes,
a good washing result is achieved by a prolonged mechanical washing action.
FAST wash programme.
The Fast wash programme is recommended when you need good results in a short
time. The programme exploits the good mechanical action and high washing
temperatures.
NEW wash programme.
The NEW programme is recommended when you wish to wash with a total change
of water in the washing tub, so for consecutive washes of particularly greasy and
dirty dishes.
The full change of the water in the tub requires a longer wash cycle.
SANITISER wash programme.
The Sanitiser programme is recommended when the dishes to be washed also
have to be sanitised.
This programme controls the wash temperature and time calculating the constant
A0. The programme ends when A0 is 30.
The length is variable, but is generally around 20 minutes and the wash
temperature reaches approximately 72 C°.
If you need an A0 value other than 30 contact an authorised technician, who will
modify the machine software for you.
4.7 Automatic cycle start-up
This function lets you start a cycle by simply closing the door without pressing any buttons. To enable
the function, proceed as follows (
Fig.4
):
The letter “ A ” on the display indicates that the function is enabled.
If not made available by default, the function must first be enabled via the
settings menu.
•
To disable the function, press START ( 3 ) for a few seconds while the door is open.
This disabling is only applied for a single wash cycle.